Electrical Chain Saw the working principle and four common faults

Electrical Chain Saw https://www.keylead.cn/Electrical-Chain-Saw

Electrical Chain Saw is an Electrical Chain Saw machine, widely used in tea cultivation, pruning, picking, although the operation is simple, but the operation is not standardized will cause the breakage rate of tea. In order to make everyone have a higher efficiency of tea picking, Electrical Chain Saw manufacturers have sorted out the Electrical Chain Saw faults and repair methods that are prone to occur, you can learn about it.

There are two working principles of Electrical Chain Saw: one is to use the bending principle to keep the coarse and old branches while picking fresh tea; The other is to hold the old and young leaves while holding the tea leaves with the fingers, and use the friction between the fingers and the tea to pick up the new leaves. Now more shear Electrical Chain Saw, the use of shear principle of tea picking. Simple structure, easy to use, popular.

Failure to rotate occurs during use

If it stops running suddenly, it may be because of insufficient power, check the next one, and charge it. In addition, there may be a short circuit in the supporting lithium battery, which needs to contact the lithium battery manufacturer for verification, the manufacturer needs to investigate and repair, and can not be disassembled by itself.

Non-start fault

In case of failure to start, first check whether the battery is sufficient. And check whether the fastener is loose, if loose, should be tightened. It may also be blocked. Clean it after the Electrical Chain Saw is closed. Technicians judge that the battery may also be due to poor contact, if there is a problem, replace the new lithium battery.

underpower

The lack of power is mainly reflected in the engine, unable to pick tea. This failure is mainly due to the battery placed for a long time without maintenance, resulting in overdischarge of the battery, resulting in performance degradation. Another possibility is blockage, which needs to be removed for cleaning.

Uneven cutting

The operation speed is too slow, the knife edge gap is too large, the blade is worn dull, and it needs to be replaced in time.

Electrical Chain Saw https://www.keylead.cn/Electrical-Chain-Saw


aubameyangclubcom

13 Blog posts

Comments